Double layer forming machine for roofing and wall panels

This double layer forming machine owns two independent forming moulds, and it is suitable for producing two types of roof panels. It is mainly composed of decoiler, roll former, cutter, hydraulic pump station, product table and control cabinet, etc. This machine adopts up and down forming type, and online automatically hydraulic cutting. It is fully automatically controlled by PLC. The most favorable points of this equipment are that it saves cost and machine spaces, thus greatly improving its production competitiveness.

Parameters of the Machine:
1. Suitable material: pre-painted coil, galvanized coil, etc.
2. Suitable thickness: 0.3-0.8mm or other thickness
3. Forming specifications: depending on specific requirements of customers
4. Forming speed: 12-15m/min
5. Main motor power: 5.5Kw (depending on specific requirements of users)
6. Cutting mode: hydraulic cutting
7. Hydraulic station power: 3Kw (depending on specific requirements of users)
8. Control system: PLC system, touch screen operation

Work Flow of the machine

De-coiling -- roll forming -- hydraulic cutting -- run-out

Main Components of the Machine

1. Decoiler ( Manual or Hydraulic) .................................. 1 set

2. Roll forming machine................................................... 1 set

3. Hydraulic cutting device............................................... 1 set

4. Hydraulic pump station................................................. 1 set

5. Product table................................................................ 1 set

6. Controlling cabinet........................................................ 1 set